BienAir Lubricare 2 Handpiece Cleaning

Automatically clean and lubricate up to 4 dental handpieces in a short time with preprogrammed operating modes suitable for each specific handpiece.


BienAir Lubricare 2 Handpiece Cleaning

Description

Fast, Effective and Cost-Saving Maintenance

Lubricare 2 automatically performs maintenance (cleaning and lubrication) of up to four handpieces in a short time thanks to different preprogrammed operating modes suitable for each specific handpiece.

It cleans a turbine in approximately 20 seconds and a contra-angle in 40 seconds.

When using Lubricare 2, oil consumption is reduced by 4 times compared to manual procedure, thus allowing for faster maintenance with excellent cost savings.

Clean Air Blowing System

By employing the dual solenoid valves system and a clean air dedicated conduit, the system can supply clean air without a mix of oil. During the water removal process before lubrication, the system removes the water in the head, which maximises lubrication results and minimises the idling period before practice.

Removable Front Door

The front door can be removed for improved access. Lubricare 2 incorporates a built-in oil mist suction mechanism to prevent aerosol diffusion when in use.

Flat Control Panel

The control panel is flat for easy cleaning.

Full Compatibility

Lubricare 2 is compatible with handpieces and cleaning or lubrication products from other manufacturers. Additional couplings or spray holder may be needed.

Technical Data

  • Cycle Duration: 20 seconds turbine, 40 seconds contrangle
  • Capacity: 4 ways (2 cleaning, 2 lubricating) and 1 chuck lane
  • Rating: AC 100 V to 240 V, 50/60 Hz
  • Power Consumption: 10 VA to 25 VA
  • Air Flow Rate: 60 NL/min to 100 NL/min (0.3 MPa to 0.5 MPa)
  • Air Pressure: 0.3 Mpa to 0.5 Mpa (recommended 0.4 Mpa)
  • Weight: Approx. 8 kg
  • Outer Dimensions: Width 300mm x Depth 300mm x Height 365mm

Price excludes installation.

Equipment Filter

For more information regarding this product...